On car Shock Bleeder

Solve the problem of air in-between rebuilds, while still getting a consistent dead bleed on your shocks, all while mounted to the car!

Easy to use!

• Unscrew bleeder screw
• Pull desired fluid into syringe
• Screw adapter into shock
• Pull slight vacuum while slowly actuating the shock, holding at fully compressed for a few seconds to allow bubbles to flow each time. 
• Repeat till bubbles stop flowing
• Compress suspension fully and hold
• Remove adapter and re-install bleeder screw before releasing suspension *IMPORTANT*

Available in M2, M2.5, and M3 thread size

* Size examples (Will add more to the list over time)

M2

• Schumacher 13mm Aluminum cap
• AE 13mm Plastic cap
• Tekno 1/10th - 1/8th

M2.5

• Schumacher 13mm Plastic cap

* Only suitable for shocks with a bleed screw on the cap, and shock setup for aeration/emulsion ( IE. NOT Bladder)